Ngàm gắn Floodlight góc 45° (Floodlight 45deg Mount)

This mount was made to attach a UP-Floodlight to a fascia panel that's shorter than the light itself, and also aim the light to its right instead of straight forward (flip LR in your slicer for opposite angle). This is not endorsed by Ubiquiti in any way.

It's intended to be used with the included flat wall mount (not the angle mount that tilts it down), and it needs to be printed out of something like ASA to withstand UV and heat outdoors.

The two mounting holes for the wall are 55mm apart horizontally, and they are slotted to allow +/- 20 degrees rotation if you want to swing it up/down but that will add some tilt too. There's a 25mm hole for the cable

As this is a reasonably complex hollow shape, be careful with your support settings so you can remove what's necessary afterwards. I did a test print on a non-Prusa printer and then used an online printing service, so no Prusa gcode, sorry.

One issue (not really with this part): if you mount it too close under gutter/ceiling, you'll struggle to get the grub screw in the top to lock the floodlight into the Ubiquiti-supplied mount. Hence the cable-tie in my photos (blocking Unifi logo but not the light/dark sensor).