Skip to main content
F3D
Đế chuyển đổi gắn quạt 92x25mm cho Orico dock 1

2 images

Dụng Cụ Tiện Ích

Đế chuyển đổi gắn quạt 92x25mm cho Orico dock

By Kuunkulta_2801056

Views
34

Files 2 976.1 KB

  • Orico_dock_base_1782565023.stlSTL · 876.8 KB
  • Optional_feet_1782565024.stlSTL · 99.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Short story: I bought a dock, the fan's noise annoyed my waifu so I spent a lot of time designing a whole upgraded bottom piece for the dock to enable upgrading to a much bigger and quieter fan.

Should be easy to print and with the upgraded airflow you don't need to worry about what material to use for printing, PLA is fine.

Dock is easy to take apart, remove feet on the bottom and you'll expose 4 screws. Take those out and the harddrive bay can now be removed, it might require a plastic spudger to get started from the edges but it's not glued and there's no clips or anything. Very straightforward.

On the bottom of the main board you'll find the fan connected with a 2-pin 5V DC power connector that you'll need to splice you new fan connection to. ONLY USE A 5V NON-PWM FAN!!

Designed for 92mm wide, 25mm thick fan, but slim fans will work as well.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
976.1 KB
Largest file
876.8 KB

0 comments

See all