SuperBase Case – Vỏ đựng cho thiết bị Meshtastic radio

License Notes

This work is licensed under a Creative Commons Attribution-ShareAlike (4.0 International License)

Copyright © 2026 MUZI WORKS

Commercial use is fully permitted under this license, meaning you are free to sell, monetize, or otherwise use this design for commercial purposes. However you must give credit, provide a link to the license, note if any changes were made and distribute your contributions under the same or a compatible license.

We would also love you see your contributions so please share them with us! 

Components Required

• Base Uno or Base Duo

• Super IO

• BASE System Battery - BB15

• [3x] M2.5 socket head screws 12mm length

Print suggestions

• Has been tested to print well with PLA, PETG, ASA

• Nozzle: 0.4mm

• Layer Height: 0.12mm or 0.16mm

• Orientation: Face down

• Support: None

Assembly Tips

• Soldering is required on the boards, alignment jig provided to print

• Make sure to align the OLED to the OLED bracket before sticking it down, removal is not recommended

• Screws require 2mm hex drive

• Full assembly instructions (including video)

• Take your time and enjoy the process!

Fits:

• Battery up to 8mm x 34mm x 55mm

• Your choice of SMA antenna

Dimensions: 

• 47.8mm x 79.5mm x 19mm [1.88in x 3.13in x 0.75in]

Purchase a pre-built device or case only from our web store:
https://muzi.works

Meshtastic® is a registered trademark of Meshtastic LLC. Meshtastic software components are released under various licenses, see GitHub for details. No warranty is provided - use at your own risk.