
Vỏ bảo vệ Hydrophone cho đĩa Piezo 27mm
- Downloads
- 0
- Likes
- 0
- Views
- 30
- Remixes
- 0
- Comments
- 0
Files 1 73.7 KB
- Hydrophon_Geh_use_1782443444.3mf3MF · 73.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #405213
- Category
- Dụng Cụ Tiện Ích
- Published
Description
It's an encasement for a hydrophone. on the bottom is a 6mm hole for the cable, in the top a small edge to rest the piezo on.
I just used a Mic-cable, pulled it through the hole, used a cable-tie as a strain relief.
The case is than filled with quick-cement to add weight. ca 3mm unter the resting edge of the piezo is a small rim to mark the max fillig. it ensures that behind the piezo is some air to let t vibrate. Then super-glued the piezo disk in. Used some epoxy to seal the top.
On the side of the case is a small loop. There you can add additional weight or a stick or similar to turn it under water.
Print spec
- Formats
- 3mf
- Model files
- 1
- Total size
- 73.7 KB
- Largest file
- 73.7 KB
0 comments
You may also like 12 models
See all-
New -

-

-
New -

-

-
New -

-
New -
New -
New -


