Skip to main content
F3D
Giá Đựng Hạt Hút Ẩm Cho Cuộn Chỉ Sunlu 1

5 images

Máy In 3D

Giá Đựng Hạt Hút Ẩm Cho Cuộn Chỉ Sunlu

By Faenum_91587

Downloads
2
Likes
1
Views
61

Files 4 22.4 MB

  • Pod_1782390590.3mf3MF · 7.5 MB
  • Pod_Hygro_A_1782390592.3mf3MF · 7.5 MB
  • Pod_Hygro_B_1782390593.3mf3MF · 7.4 MB
  • baffle_1782390595.3mf3MF · 2.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A filament holder for Sunlu refillable spools only. It can go wherever your filament can go, inside your dryer, inside your dry box. It is designed for optimum drying and makes use of the holes in the spool.

If you want to add a hygrometer you will need to print 1 each of the hygro A and hygro B parts, plus 4 of the pods. If you don’t want a hygrometer, just print 6 of the pods. you will also need 6 of the baffle parts, they slide in between the pods and help to add structure, I printed mine in a blue similar to the spool so it matches. I used a contrasting colour for the pods, which is a free roll of PLA, but its up to you what you choose, it can be printed with anything, could even be rainbow.

You will also need to make/buy small mesh bags for the desiccant beads, otherwise small pieces will fall through the holes. Place your bags of beads in each pod, then slot them into the holes on both sides of the spool, 3 pods on each side, then put the spool back together. You can slide the baffle pieces in either before putting it together or after, its mostly just cosmetic. The hygrometer just slots into the hole once the spool is back together. No glue is needed and its very easy to pull apart if you need to change out the beads or do other maintenance.

Read more Show less

Print spec

Formats
3mf
Model files
4
Total size
22.4 MB
Largest file
7.5 MB

0 comments

See all