Giá đỡ/Kẹp BC250 Microfit

A simple clip/holder for the micro-fit 3.0 power connectors on the bc250.

First time 3d modeling or posting here so it's not the best but it works. I'm fairly sure no one else has made this, so here's a simple clip/holder for the microfit 3.0 connectors I made. Made with my very limited 3d modeling knowledge, so if someone else wants to improve it feel free!

It's designed to not need supports, when printing auto orient it/print with it pointing up and I'd recommend PETG.

To install, as it is a tight fit, you might need to bend the clip to fit it on. It is also keyed left and right. You can either insert the microfit and then put the clip or put microfit into the clip then insert the microfit. it's designed to block the outside (non 12v/gnd pins) to hold it as well.

Enjoy!