
Tấm chặn mặt sau (Backplate) lắp USB-C cho SNES (Hỗ trợ 9v Trigger Board)
Remix of Tấm ốp lưng độ nguồn USB-C cho SNES (sử dụng mạch Adafruit) By AyleenDayoss_191639
- Downloads
- 1
- Likes
- 3
- Views
- 91
- Remixes
- 0
- Comments
- 0
Files 3 543 KB
- SNES_USB-C_Backplate_Standard_1782358232.stlSTL · 173.4 KB
- SNES_USB-C_Backplate_Vertical_1782358233.stlSTL · 170.4 KB
- SNES_USB-C_Backplate_no_RF_1782358234.stlSTL · 199.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #403916
- Category
- Dụng Cụ Tiện Ích
- Published
- License
- Creative Commons — Attribution
Description
Intended to allow you to modify your console to run off of USB-C. By installing a USB-C trigger board configured to output 9 volts, you can power the system with any USB-PD compatible power supply without changing any of the original operations of the console. This is superior to other USB-C mods that run off of 5 volts as it allows for more stable power delivery and is more in-line with the systems intended operations.
Designed for use with the specific kind of trigger board pictured, they're commonly sold on places like AliExpress and Amazon. When I bought some most recently they were being sold under the name "Jacobsparts" but I doubt they still are.
Designing this was a balancing act between making installation of the trigger board easy/accessible, vs. ensuring that the board is securely installed. I tried various lengths for the retaining wall at the end of the mount, with .7mm being slightly too easy to remove, and .11mm being very difficult to install. This model uses a .9mm wall, but this can be adjusted easily. Just pop the socket into place with a little bit of force. Once inserted it is very secure.
I included three versions. The "standard" version mounts the board upright but blocks he installation of the leftmost screw. This is not an issue and the backplate is still very secure. If this bothers you though, the "vertical" version mounts the board vertically and will allow you to install that screw. The "no RF" version is just for if you're already removing the RF modulator, for some reason.
Should work with all North American non "Jr" Super Nintendos.
Should work with PLA and PETG at least but tolerances can be tight and may need to be adjusted for other materials. Be mindful of print orientation and support surfaces.
Print spec
- Formats
- stl
- Model files
- 3
- Total size
- 543 KB
- Largest file
- 199.2 KB












