Skip to main content
F3D
Giá đỡ HP Docking Station G6 gắn dưới mặt bàn 1

8 images

Dụng Cụ Tiện Ích

Giá đỡ HP Docking Station G6 gắn dưới mặt bàn

By klingele28_2481229

Downloads
4
Views
48

Files 4 665.1 KB

  • HP_Dock_G6_Halter_1781214912.stlSTL · 445.2 KB
  • HP_Dock_G6_Netzteilhalter_1781214913.3mf3MF · 48.7 KB
  • HP_Dock_G6_Netzteilhalter_1781214913.stlSTL · 35 KB
  • HP_Dock_G6_Halter_1781214914.3mf3MF · 136.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

um meine HP Dock G6 unterhalb des Schreibtisches zu befestigen, habe ich einen Halter konstruiert.

Die Dock wird einfach eingeklickt und alle Anschlüsse sind frei zugänglich. Die Belüftung ist auch gewährleistet. Ein Halter für das das Netzteil ist ebenfalls verfügbar.

Um den Dock Halter zu befestigen habe ich 4Stck. 3.5 x 20mm Holzbauschrauben verwendet.

Gedruckt in PLA Silk silver. PLA reicht hier vollkommen aus, jedoch min. 3 Perimeter würde ich empfehlen.

 ---------------------------------------------------------------------------------------------------------------------------

Technical Description

This custom mounting bracket for the HP Dock G6 is designed for under‑desk installation to achieve a clean workspace layout while maintaining full functional accessibility.

The dock is held in place using an integrated snap‑fit retention system. The geometry provides sufficient elastic deformation during insertion and ensures a secure, vibration‑resistant locking position once engaged. All I/O ports remain unobstructed, and the design maintains adequate airflow around the device to prevent thermal buildup.

A dedicated power‑supply holder is included as a separate component, allowing cable routing and load distribution independent of the main dock mount.

Mounting Specifications

The bracket is fixed to the underside of the desk using 4 × 3.5 × 20 mm wood screws. The screw bosses are dimensioned to withstand repeated load cycles and provide sufficient pull‑out resistance in typical wooden desk materials (MDF, particle board, solid wood).

Printing Specifications

  • Material: PLA Silk Silver

  • Minimum wall thickness: ≥ 3 perimeters recommended for structural rigidity

  • Infill: 20–30% (grid or gyroid) is sufficient for this application

  • Print orientation: Flat on the back surface to ensure dimensional accuracy of the snap‑fit features

  • Supports: Not required for the main bracket; minimal supports may be needed depending on slicer settings for the PSU holder

The design is optimized for single‑piece printing, minimal post‑processing, and long‑term mechanical stability under static load.

Read more Show less

Print spec

Formats
3mfstl
Model files
4
Total size
665.1 KB
Largest file
445.2 KB

0 comments

See all