
Bộ Nâng Cấp Máy Sấy Filament Creality Space Pi Plus
- Downloads
- 13
- Likes
- 7
- Views
- 274
- Remixes
- 0
- Comments
- 0
Files 7 5.4 MB
- SpacePiPlus_riser_Det1_1781210690.stlSTL · 36.8 KB
- SpacePiPlus_riser_Det4-TPU_1781210691.stlSTL · 15.5 KB
- SpacePiPlus_riser_Det3_1781210692.stlSTL · 90 KB
- SpacePiPlus_Fitting_filament_1781210693.stlSTL · 808.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #401772
- Category
- Máy In 3D
- Published
Description
SpacePiPlus_Fitting_filament. Bolt with nut and channel for PTFE tube and plastic thread. It is installed at the regular outlet points of the filament (instead of rubber plugs) of the Creality Space Pi Plus dryer (it is necessary to drill a hole of about 1 mm with an 8.5 mm drill). Solves three tasks: - holds the tube with the thread vertically, preventing it from bending at the outlet of the dryer; - there is a stop for the tube, preventing the tube from entering the dryer; - it has an expanding opening for thread entry, ensuring smooth plastic entry regardless of the fullness of the coil. It can be used to attach a tube with a filament to any surface up to 5 mm thick.
SpacePiPlus_riser. A lift and lid opening limiter for the dryer. The Creality Space Pi Plus dryer has two huge drawbacks: - the bottom of it heats up very much and can damage the furniture on which it stands; - the lid tilts 180 degrees back, taking up a huge amount of space and risking breaking the frail hinges. There are many solutions to these problems online, but I didn't like any of them. My option: 1. Raises the dryer 22 mm above the surface, which eliminates heating of the latter. 2. Securely locks the lid in the raised state, keeping the dryer's dimensions to a minimum and minimizing the load on the hinges. 3. the shape of the freezer "continues" the outline of the body, creating a single unit with the dryer. The opening limiter is made of a round shape, which repeats the design of the model and ensures reliable fixation of the lid (unlike other limiters, which create an additional load on the hinges). It is attached to the bottom of the dryer using double-sided adhesive tape 20 mm wide and 1 mm thick (4 pieces of 45 mm each). The model has special recesses for this. The stand legs and the stop pad under the lid are printed from TPU.
SpacePiPlus_container. A small container basket for drying silica gel sachets (and their further use with vacuum bags for storing the filament). It was made based on a model found on the web, unfortunately I lost the link. Print from ABC.
I highly recommend printing the deflector as well. Prevents hot air (90 degrees) from entering the thread spool. I tried all the deflectors I found and made my own, but this one turned out to be the best. Print from ABC. https://www.printables.com/model/1326140-creality-space-pi-plus-heat-deflector
Print spec
- Formats
- stl
- Model files
- 7
- Total size
- 5.4 MB
- Largest file
- 4.4 MB
0 comments
You may also like 12 models
See all-

-
New -
New -

-

-

-

-

-

-

-

-


