Bản Mod Ballast Cho V-Spooler

This is a ballast mod for V-Spooler. There are various reasons why you may be interested in this mod:

• V-Spooler is a bit top-heavy before you do your re-spooling. This lowers the center of gravity.

• More stable

• Potentially quieter, as the mass should hopefully reduce any vibration

The ballast mod is essentially a little box that attaches under V-Spooler that you fill with concrete (or whatever) to add weight to. There are a couple of versions available initially:

• Smaller (lighter) and larger (heavier) versions

• Variants for the current V-Spooler and current motor mod

The normal V-Spooler version requires the following components to build:

• 8x M3 inserts

• 8x M3x8 screws and washers

• Ready mix concrete

The motor mod version requires the following parts:

• 16x M3 inserts

• 16x M3x8 screws and washers

• Ready mix concrete

If you are building the motor mod version you will need a hex wrench or driver that can go deep enough to connect the part that goes under the motor mod to the part that connects to the main body.

Instructions will come shortly!

If you find this model useful please consider supporting me by joining my club here on Printables even if only for a month. Thank you!