
Khối gắn kết (Mounting Block) cho Synology TC500
- Downloads
- 0
- Likes
- 0
- Views
- 27
- Remixes
- 0
- Comments
- 0
Files 1 56.3 KB
- Round_Mounting_Block_-_75mm_1780719526.stlSTL · 56.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #398399
- Category
- Dụng Cụ Tiện Ích
- Published
Description
I made this mounting block for the Synology TC500 camera as an adapter between a standard articulating arm mount and the manufacturer base for the camera.
This model is, for all intents and purposes, a slightly beveled cylinder, printed with a high infill percentage, and then intended to absorb screws from each mounting bracket type.
Some notes on printing and installing:
-
I have printed mine in PLA with a 80% infill, but PETG would likely be even more robust.
-
The block is 75mm in diameter and 25mm thick, and 3/4" screws on the arm side, with 1" screws from the Camera side.
-
Both screw types were the counter sink style with a course thread.
-
Once printed, I used the mounting plates from each side of the system to mark the block and then pilot drill.
-
PLA Melts so plan to clean your bit. Also, don't over screw or it will crack the block (especially with high infill).
-
I had considered going back and making indents or pre-formed holes in the pattern of the brackets before publishing, but realized others might have different brackets that might not match up...so yeah it's a plastic cylinder of about the right size...
Final Thoughts:
- This same problem could have been solved more or less the same way with a chunk of wood, but I had more filament lying around than lumber, so here is a properly sized thing that does the job.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 56.3 KB
- Largest file
- 56.3 KB
0 comments
You may also like 12 models
See all-
New -

-

-
New -

-
New -
New -

-
New -
New -

-


