
DIY
Kẹp ống trống Yamaha 38x38mm
- Downloads
- 0
- Likes
- 0
- Views
- 32
- Remixes
- 0
- Comments
- 0
Files 1 5.9 MB
- 38mm_pipe_clamp_hanger_1780686866.stlSTL · 5.9 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #397561
- Category
- DIY
- Published
Description
When I got a few mesh pads and replaced the rubber pads on my Yamaha drum kit, it felt like a waste not to use the latter to expand the kit a bit. Mounts for the tube were needed. This is exactly that kind of holder :)
To ensure strength, print at a 45-degree angle (as shown in the photo) with a gyroid infill of at least 50%. Also, add supports in the gaps. My knob with an M6x40 nut and bolt fits this holder:
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 5.9 MB
- Largest file
- 5.9 MB
0 comments
You may also like 12 models
See all-
New -

-
New -

-
New -

-

-

-
New -
New -
New -
New

