Skip to main content
F3D
Bản Remix: Chuông gió Hooting Owl dùng cuộn Prusament 1

4 images

Đồ Gia Dụng

Bản Remix: Chuông gió Hooting Owl dùng cuộn Prusament

Remix of Chuông gió Cú kêu “Hooting Owl Wind Chime” By mindthelight

By mindthelight

Downloads
1
Likes
4
Views
106

Files 6 9.2 MB

  • Spool_Remix_-_HangerPin_1780678044.stlSTL · 3.6 KB
  • Spool_Remix_-_HexStriker_1780678045.stlSTL · 1 MB
  • Spool_Remix_-_HexSail_1780678046.stlSTL · 1 MB
  • Spool_Remix_-_LowerBase_1780678047.stlSTL · 3.1 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

With this remix you can use one of your empty Prusament spools to mount the Hooting Owl Wind Chimes. It comes with a matching hex striker and sail.

Printing

Use the provided 3mf file to print directly.

Otherwise, print all models once except for the pegs for which you need nine.

  • works with PLA however keep in mind the colors may fade in the sun

  • 0.2mm layer height

  • no supports needed

  • if the pegs are too tight, scale them a little bit

Assembly

  • Disassemble an empty Prusament spool. You need one half.

  • Put a thread through the sail and striker, fixing both with a knot. Secure the thread on the other side at the lower base. Stick the lower base through the bottom (inner) hole of the spool side and screw on the cap from the other side.

  • Push three pegs from the bottom (inner) side of the spool (the pegs should be pretty tight) into three hexagonal holes at roughly 120 degrees distance. Use these pegs to mount the whole wind chime.

  • Push the remaining six pegs, two between each of the pegs from the last step, at roughly same distances. Use these pegs to mount the owls.

Sources

As always, here are the onshape sources for tinkering.

Read more Show less

Print spec

Formats
3mfstl
Model files
6
Total size
9.2 MB
Largest file
3.1 MB

0 comments

See all