
Cổng nguồn lọc cho máy in Voron 2.4
- Downloads
- 47
- Likes
- 6
- Views
- 603
- Remixes
- 0
- Comments
- 0
Files 4 2.5 MB
- rear_power_inlet_skirt_b_300_1765871918.stlSTL · 329.9 KB
- rear_power_inlet_skirt_a_300_1765871919.stlSTL · 679 KB
- rear_power_inlet_skirt_ab_300_1765871920.stepSTEP · 897.4 KB
- Schaffner_FT261_FN9260_eng_tds_1765871922.pdfPDF · 619.5 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #38850
- Category
- Máy In 3D
- Published
- License
- GNU General Public License v3.0
Description
Power rocker switch moved to the either left/right front side skirt of the Voron 2.4
This is a mod of the rear AB skirt for a Voron 2.4
Compatible with a 300 build size Voron 2.4.
# Bill Of Materials
- 1x FN9260B-10-06 - Power Inlet with Filter (Distrelec Article Number: 301-09-731 / Manufacturer Part Number: FN9260B-10-06)
- 1x RND 170-00002 - Fuse 5 x 20mm, 10A, 250V (Distrelec Article Number: 300-43-422 / Manufacturer Part Number: RND 170-00002)(fuse is not included with the outlet)
- 5x M3 Heat-set insert
- 2x M3x8 SHCS
- 2x M3x6 BHCS (SHCS will also work)
# Instructions
- Print the skirt for the side you want to mount the filtered power inlet on.
- put the power inlet inn to the hole and fasten it with two M3x6 screws.
- insert the fuse into the power outlet.
- Remove the stock skirt piece from your Voron 2.4 and install the new one in it's place.
#Print settings (Recommended by Voron team)
- Infill: 40%
- Wall count: 4
- Solid top/bottom layers : 5
# Inlet info
- Rating: 10 A, 250 VAC
- Contact Configuration: 2NO
- Panel Cut Out Width: 33.3mm
- Panel Cut Out Height: 29.3mm
- Mounting Type: Screw
This is a mod of the skirt that was designed by the Voron team : https://github.com/VoronDesign/Voron-2
Print spec
- Formats
- pdfstepstl
- Model files
- 4
- Total size
- 2.5 MB
- Largest file
- 897.4 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-

-

-


