Bản remix Polymaker Polydryer blower quiet mod - Sử dụng ốc M4

A simple remix of the upper duct piece to allow the use of M4x35mm button-head bolts instead of using the printed pegs. This gives you a little more tolerance and the hardware is a bit stronger than the printed pieces.

Instructions

Follow the instructions at the original model. Print the following parts:

• Polymaker_Blower_Adapter_duct.stl (from the original model)

• Polymaker Polydryer blower quiet mod REMIX-upper part.3mf (here)

• Polymaker Polydryer blower quiet mod REMIX-lower part.3mf (here)

You will also need:

• 2x M4x35mm button-head bolts (McMaster, AliExpress)

• 2x M4 nuts (McMaster, AliExpress)

Flat-head bolts will work fine, but regular socket head bolts will not (unless they're low-profile). M3 bolts/nuts will work too, but they won't sit as securely.

Recommended Print Settings

• 0.4mm nozzle

• 0.2mm layer height

• 10% infill (depending on material you may want this higher for smooth flat ceilings)

• A heat-resistant filament, such as PETG or PA

• Print as oriented