
Con lăn tay gai (spiky hand roller) với printed bearings
- Downloads
- 34
- Likes
- 13
- Views
- 200
- Remixes
- 0
- Comments
- 0
Files 3 12.9 MB
- dual_roller_short_1778884824.3mf3MF · 4.8 MB
- dual_roller_long_1778884826.3mf3MF · 4.7 MB
- dual_roller_gear_bearing_print_4_1778884827.3mf3MF · 3.3 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #386607
- Category
- Sức Khỏe
- Published
- License
- Standard Digital File License
Description
Someone suggested to make a hand roller using my printed gear bearings - so I did, also throwing in a spiky texture.
Printing:
-
This model requires good precision and a well dialed-in printer and filament combination!
-
Main parts:
-
bed contact area is small for the rollers, good bed adhesion is a must - otherwise try a brim.
-
standard settings
-
-
Bearings:
-
print 4 of these
-
0.17mm layer height
-
random seams
-
elephant foot compensation (e.g. 0.15)
-
if unable to break free, see tips here.
-
Assembly:
-
Break free and break in the bearings. Use one of the axles as grip to turn the gears a couple of times. Maybe apply some pressure on the outer ring while doing so, from multiples directions. I often use a power drill with the axle clamped in.
-
Optionally use a tiny bit of light oil as lubricant for the gears for extra smoothness.
-
Push one(!) bearing into a roller cylinder. Make sure it doesn't get tilted, push hard, it needs to sit flush.
-
Insert axle from the other side, the end sticking through the bearing.
-
Push second bearing over the axle into the roller. It needs to sit flush with the roller, the axle sticking out on both sides.
-
Do the same for the second roller
-
Push both rollers into one connector cap.
-
Attach the other connector cap
-
Firmly press both connector caps so they click in, the axles should sit flush in their holes, see images.
Print spec
- Formats
- 3mf
- Model files
- 3
- Total size
- 12.9 MB
- Largest file
- 4.8 MB












