Giá đỡ cạnh nắp/vỏ K1 Max

A simple way to store the top cover of the K1 Max when it's not in use.  I didn't like leaving it lying around or leaned up against something so I designed these rails to allow it to be stored with the printer safely and without taking up much room.  You will need 4 M3x8 flathead screws to install the rails as the stock ones aren't long enough.  

You should be able to print this out of just about any material since the side panel should never get hot enough to cause any issues.

8-16-23

Addes STL files because Creality Print doesn't seem to like the 3MFs.

(As an aside, it is shockingly hard to get good photos of a cube covered in semi-reflective surfaces)