
Ống Tiêm/Đầu Bơm Chất Lỏng (Liquid Dispenser Syringe)
Remix of Flux Dispenser - Ống tiêm in 3D hoàn toàn (Fully 3D printable) By shadow_4173343
- Downloads
- 5
- Likes
- 0
- Views
- 43
- Remixes
- 0
- Comments
- 0
Files 4 4.8 MB
- dispenser_inner_body_1778859437.objOBJ · 1.1 MB
- dispenser_body_1778859437.objOBJ · 1.5 MB
- Liquid_Dispenser_Syringe_-_2026-05-10_19_37_42_1778859439.3mf3MF · 275.7 KB
- Liquid_Dispenser_Syr_1h18m_PLA_COREONEL_1778859439.bgcodeBGCODE · 1.8 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #385336
- Category
- DIY
- Published
Description
Point of this remix was that it should be able hold a liquid like water. Original model was good for paste like fillings.
Print it next to each other. Don't Print it as one piece.
Printed with PLA. Layer height 0.2 mm. Brim recommended. Density 20%.
It can hold aprox. 15 mililiters of a liquid.
Add a rubber o-ring for top part. I used 10mm wide, 1mm thick one.
Printed with easy print with Prusa Core L One. The design works. Tolerance might be too tight, then use more force when putting together. One the o-ring is there, you might use a bit of grease on it for a better slide. Due to FDM prints imperfections it might drip a little. But it is good enough for a seasonal use.
not for medical or food practices
Print spec
- Formats
- 3mfbgcodeobj
- Model files
- 4
- Total size
- 4.8 MB
- Largest file
- 1.8 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -
New -

-

-
New -

-
New

