Giá/Holder cất Pinball Art Blade Protector Holder

NOTE!

Main cover photo is the original version, photos and pics show both versions.

Original Version:

Ever wondered how to store your Pinball Art Blade Protectors? Well perhaps not but I did!

These simple prints are designed to be stuck to the back of your pinball machine using standard 5925F 3M VHB tape to receive your covers.

Installation - stick some VHB tape in the groove on both holders, put your blades together along with the protectors and put them on the back of a machine in the rough position I have them in on the back of mine. 

Once you are happy with the position mark the back of the machine with the position of one or both of them. Remove the protectors and holders. Check your pencil marks for level (doesn't needs to be spot on of course). Then remove the VHB backing and fix in place using the pencil marks as guides.
 

Done.

Printing - use the 3MF file or the STL. Default printer settings should be fine.

Alternate Version:

 This should be quicker to mount than the original version. You should be able to get away with just the larger of the two sections if you are mounting vertically. However, if you print two or three of the alternate parts you should be able to mount them under a table to carry the protectors horizontally. I've included screw holes for this purpose. Make sure your screws are of the appropriate length if you choose this!

 As before you can fit 3M tape to the recesses.

NOTE:

These were designed for the protector blades that arrive rolled up. If yours were rigid then you might need to enlarge the print a little (not a lot because the tape will sit to far into the groove - or use thicker tape) to take the extra thickness. If you aren't sure either print just one or a section of one to test!

If you have any problems - leave feedback!