
Gerätehaken - Móc treo thiết bị (Equipment hook)
- Downloads
- 1
- Likes
- 0
- Views
- 43
- Remixes
- 0
- Comments
- 0
Files 1 2.4 MB
- Geraetehaken_1778354420.stlSTL · 2.4 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #380786
- Category
- DIY
- Published
Description
Dieser Gerätehaken ist stark und einfach zum Montieren. Er wird auf einer Leiste (2cm x 3cm) montiert, sodass nur zwei Löcher pro Reihe in die Wand gebohrt werden müssen. Das Gewicht des Werkzeugs liegt so nicht auf den Schraublöchern, sondern auf der ganzen Breite der Konstruktion.
Ich habe es auf der Seite liegend mit 0,2mm Schichthöhe, 3 Wandreihen und 20% Füllung (Gyroid) aus PLA gedruckt. Stützstrukturen müssen eingeschaltet werden.
Es ist wichtig, dass es seitlich liegend gedruckt wird, weil dies dem Haken die beste Stabilität gibt.
Ich hoffe, Ihr habt soviel Freude daran, wie ich!
This tool hook is strong and easy to mount. It's mounted on a 2cm x 3cm strip, so only two holes per row need to be drilled into the wall. This way, the weight of the tool isn't borne by the screw holes, but distributed across the entire width of the hook.
I printed it on its side with a 0.2mm layer height, three wall rows, and 20% infill (gyroid) using PLA. Support structures must be enabled.
It's important to print it on its side because this gives the hook the best stability.
I hope you enjoy it as much as I do!
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 2.4 MB
- Largest file
- 2.4 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-
New -
New -
New -

-

-
New -

-
New

