
Giá đỡ cuộn filament PRUSA cải tiến từ Devilscave
Remix of Giá đỡ cuộn filament Ultimate V3+ cho Prusa MK3/s theo phong cách TUSH By Devilscave
- Downloads
- 191
- Likes
- 35
- Views
- 3,597
- Remixes
- 2
- Comments
- 13
Files 3 325.8 KB
- PRUSA_i3_MK3_Spool_Holder_Part_2_Bolt_Side_1765539839.stlSTL · 174.7 KB
- PRUSA_i3_MK3_Spool_Holder_Part_1_Nut_Side_1765539840.stlSTL · 140.1 KB
- PRUSA_i3_MK3_Spool_Holder_Part_3_Kickstand_1765539840.stlSTL · 11 KB
Make a variant with AI
Build another version of this model.
Remix versions 2
Giá Đỡ Cuộn Dây PRUSAByvincele · 12/15/2025
Giá đỡ cuộn filament Prusa i3 cho cuộn 2kg và 3kgBygeorgag · 03/25/2025
Details
- Model ID
- #37951
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
This print was remix of the Devilscave spool holder done using SketchUp, Blender and PRUSA Slicer
A comment was made in the original file on Thingiverse that indicated they wished the original could be printed without supports. So I remixed this and clipped off the conflicting side and added little more material for strength at the connection point.
I believe the width of the end was needed for stability if you were to place this on a table or a shelf.
As Devilscape says, the original design was inspired by the TUSH design. Within the TUSH comments there was a lot of concern regarding stability when near the end of a spool or if the filament would pinch, and it would pull the spool off the holder. I solved this by using the original holder as a back up - see photo. In this photo, the spool rides the bearings but can use the original holder if needed, however I have not experienced stability problems with my use of this design.
As in the original Devilscave design, the Prusa Spool Holder uses:
8 M3-0.5x20mm Socket Cap Screws;
8 M3-0.5 Nylon Lock Nuts;
4 608 inline skate bearings.
My initial print is in PLA and I will determine if I need to print in PETG later as I watch it perform under the weight.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.2
Infill:
20%
Filament:
Polaroid Pro PLA (initial) Black
Notes:
Since this is a remix, it uses the same instructions as the original.
Category: 3D Printer Accessories
Print spec
- Formats
- stl
- Model files
- 3
- Total size
- 325.8 KB
- Largest file
- 174.7 KB
13 comments
You may also like 12 models
See all-

-

-
New -
New -

-

-

-

-

-

-

-


