Skip to main content
F3D
SuckMate (cánh tay đỡ ống hút bụi / vacuum Hose arm) 1

2 images

DIY

SuckMate (cánh tay đỡ ống hút bụi / vacuum Hose arm)

By HelgeHelgeson

Downloads
2
Likes
2
Views
104
Remixes
1

Files 5 1.4 MB

  • Angle_Insert_1.0_1778182160.stepSTEP · 85.5 KB
  • Arm_Part_1778182160.stepSTEP · 598.2 KB
  • Arm_Part_-Mount_1778182161.stepSTEP · 546.2 KB
  • Angle_Insert_0.8_1778182162.stepSTEP · 85.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

I designed my own Printable arm (Inspired from the Festool Boom Arm )
to have your "sucker" all the time at the correct place without throwing everything from your table. 

Its designed to hold an 40mm Hose (or smaller) maybe bit bigger would work as well.
you need to have a 19-20mm rod to place the Arm mount on it. 
I printed the Arm mod with the lower flat base on the Printbed and used a Brim (don't know if really needed)
The Arm Parts are best to print flat on the Bed

I used PETG for the whole system. and there are some Supports needed 

it's kind of important to use the Cableclip after you installed the Arms and putted the Hose inside. -> They give some strength to the design (Holding them together)

the Inserts are to use if you need bit less curve in the Arm. just place them from the bottom between two Arm parts (they should clipin"

Hope that thing is working at your place like it does at mine ! 

cheers and have fun

Read more Show less

Print spec

Formats
step
Model files
5
Total size
1.4 MB
Largest file
598.2 KB

0 comments

See all