
DIY
Bánh xe vặn kẹp (clip-on) cho Mantis Clamp
Remix of Mantis Clamp - Hệ thống kẹp bánh răng hành tinh 2 cấp in nguyên khối By zuberio
- Downloads
- 122
- Likes
- 20
- Views
- 568
- Remixes
- 0
- Comments
- 0
Files 1 1.9 MB
- wheel-Body_1777829273.stlSTL · 1.9 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #373762
- Category
- DIY
- Published
Description
Print and clip on! It's sized to grip the hex dial firmly but not so hard that it's difficult to get on. At least, on my printer. Your mileage may vary.
Filament: PLA
Layer height: I used 0.20mm , same as the clamp itself. It's probably worth matching the two.
Perimeters: 3
Infill: triangle, 15% but probably doesn't matter too much.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 1.9 MB
- Largest file
- 1.9 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-
New -
New -
New -

-

-
New -

-
New
