Skip to main content
F3D
Núm vặn cho bu lông 7/16 tiện lợi và dễ sử dụng 1

4 images

DIY

Núm vặn cho bu lông 7/16 tiện lợi và dễ sử dụng

By TheRetroRelic_967548

Downloads
26
Likes
5
Views
375

Files 2 1.7 MB

  • 7.16_bolt_cap_1766350637.stlSTL · 1.4 MB
  • 7.16_bolt_knob_1766350638.stlSTL · 246.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a knob for a 7/16 bolt. You simply slide the bolt through the hole and fasten the cap with 3- 3x8mm screws. DO NOT over tighten. the screws create a thread as you insert them. Fit will depend on your specific printer. If the fit is very tight you can tighten a nut onto the bolt to pull the bolt head through into the head pocket. Another option is to upscale a few percent till you get the correct fit.

I designed this for a bolt that tightens a custom steering wheel tilt on a go kart. Lots of practical use cases. Can be scaled up and down, I recommend fastening the cap with glue instead of screws if downscaling. Enjoy

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
1.7 MB
Largest file
1.4 MB

0 comments

See all