Skip to main content
F3D
Scrapers [WIP] – Các mẫu scraper (đang hoàn thiện) 1

3 images

DIY

Scrapers [WIP] – Các mẫu scraper (đang hoàn thiện)

By engineeringwithlui

Downloads
26
Likes
2
Views
131

Files 1 212.1 KB

  • flat_scraper_v6_1777739583.stlSTL · 212.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Needed a new scraper, could have printed one of the many already on printables, but where's the fun in that!?

Notes

  1. This is a WIP so more tweaks and scrapers will be added, below in the next heading will detail each scraper against versions and dimensions 
  2. A deburring tool is your best friend, if you don't have one, get one off eBay or wherever you get your gear from!
  3. The curve of the scraper end (smooth part) relies on some tweaking of some settings
    1. adaptive layer height
      1. enabled (under experimental in cura)
      2. tweak and adjust accordingly to the layer height you're printing
    2. ironing
      1. enabled
      2. may not need if using a small layer height

Scrapers & Dimensions

  1. Flat & slim 2mm thick with extra grip
    1. Notes
      1. The ending is flared out so it sits in the crevices of your hand easier to reduce slip
      2. Kind of flimsy, but flexible, you could snap it if you try hard enough but has enough of give for most use cases
      3. The purple images, the print was a 0.2mm quick-n-dirty print with both tweak settings mentioned above enabled
    2. Dimensions
      1. Thickness - 2mm
      2. Length - 118mm
      3. Width portion - 55mm (actual scraper part)

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
212.1 KB
Largest file
212.1 KB

0 comments

See all