Vỏ PiKVM cho Pi Zero 2W với HDMI CSI Bridge (Waveshare)

just like in the original, to get the honeycomb pattern I've adjusted my slicer settings to:

wall loops: 5
top shell layers: 0
bottom shell layers: 0
sparse infill density: 25%
sparse infill pattern: honeycomb

feel free to stack and re-use any of the original model parts as they are all compatible

can either be used with zipties or with long m2 screws

you can screw in the bridge in the middle posts too, but in my testing just resting on top is enough to prevent any movement

depending on which way your flat ribbon cable bends, you might need to reverse this design upside down once printed

the sandwich pictured from top to bottom:

1. hdmi-csi-top-cutout
2. hdmi-csi-bottom (raspi strapped upside down and flat to the bottom of it with no spacers)
3. top_open2 (to leave plenty room for the pi; acts as a bottom if your cable wraps around the other way)