
Bộ gá đèn (worklight/lightbar) cho ROP của JD 3038e (gen 1)
- Downloads
- 15
- Likes
- 2
- Views
- 142
- Remixes
- 0
- Comments
- 0
Files 8 4.1 MB
- ROP-double-work-light-clamp-v2-Body2_1777678097.stlSTL · 312.7 KB
- ROP-double-work-light-clamp-v2-Body1_1777678098.stlSTL · 504.8 KB
- ROP-work-light-clamp-v7-Body2_1777678099.stlSTL · 312.7 KB
- ROP-work-light-clamp-v7-Body1_1777678100.stlSTL · 404 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #361035
- Category
- Đồ Gia Dụng
- Published
Description
Mounts for lightbar or worklights to be mounted on a ROP with approximate cross section dimensions of 53x79mm (or nominally 2x3"). These worked fine on my gen 1 (2010) JD 3038e tractor. Clamps will show a gap after being tightened around the ROP. Do not over-tighten.
Assembly of the clamps is done with M5 cap head screws and nuts. Recesses for nuts are included in the clamp walls. The single mount clamp was intended for use with a lightbar that uses an M6 screw. The dual mount clamp was intended to accomodate a worklight with an 8mm mounting bolt.
Printing should be done with a material UV and temperature stable. I would recommend using ASA. Multiple perimeters should be used to increase strength. I would recommend 3mm thick walls, top & bottom, and at least 25% infill.
Fusion 360 source and .STEP files are included.
Print spec
- Formats
- f3dstepstl
- Model files
- 8
- Total size
- 4.1 MB
- Largest file
- 1 MB
0 comments
You may also like 12 models
See all-

-

-
New -
New -

-

-

-

-

-

-
New -


