
Kẹp lò xo giữ HEPA filter (Custom) – HEPA FILTER SPRING CLAMP(Custom)
- Downloads
- 5
- Likes
- 5
- Views
- 69
- Remixes
- 0
- Comments
- 0
Files 1 79.7 KB
- Spring_Clamp_V100RFInal_1777660884.stlSTL · 79.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #359721
- Category
- DIY
- Published
Description
This is a robust and durable spring clamp. This is designed to hold 3ft by 2ft and 20-inch deep large HEPA MERV 16 Air Filters in a steel frame. The front of the filter has a 20 mm depth from the lip of the steel frame it sits over to the front of the HEPA filter, effectively holding it seated against backpressure. The springy clip goes over the frame and pushes on the front of the HEPA filter, keeping it in place when the gas turbine is tripped offline and an instantaneous backpressure happens.
This is designed to be printed at a full 80% infill for strength of spring action and durability. Archimedean chords are used on infill for spring-like action, which they provide to the final product. It is a great base model for a powerful spring clip. Many prototypes were tested to come up with this final design. It produces a large amount of clamping force for the steel plate frame it slips over. It took more than 40 ft-lbs of force to push the clip sideways once installed in the air filtration box frame. This could come in handy as a starting point for a strong clamp for some folks. Its purpose is to hold 252 HEPA filters in a large industrial HEPA air filtration system located on a very large Westinghouse Gas Turbine. Temperature extremes can go from -10°F to 80°F, hence I used ABS in my design.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 79.7 KB
- Largest file
- 79.7 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-
New -

-

-


