
Bạc đạn skateboard – Không có bi (22-8-7 mm)
- Downloads
- 63
- Likes
- 6
- Views
- 432
- Remixes
- 0
- Comments
- 0
Files 4 1.7 MB
- 9V.3-TwistLoose_1777647381.stlSTL · 5.2 KB
- 9V.2-OutterRace_1_1777647382.stlSTL · 426.8 KB
- 9V.1-InnerRace_1_1_1777647384.stlSTL · 326.4 KB
- CE3E3V2_9V-SkateBearing-NoBalls_v9_1777647384.gcodeGCODE · 1,010.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #358532
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
I’ve made some ball bearings with PLA and found that they typically have a sticky point or two.
My perception that PLA on PLA surfaces have pretty low friction, turned out to be correct. This bearing has a V shape interface between the inner and outer rings.
Prints in a single print without supports.
it is nowhere as strong as a steel ball bearing, but is appropriate for many low-load PLA projects that require a turning shaft to be supported with loads appropriate to PLA.
Do NOT use it to support a skateboard and human.
The clearance between the 2V shapes load surfaces is 0.3 mm.
I had no luck separating the Outer and Inner Races until I added a slot and twister. I don't think the slot will affect your mating shaft. To separate the races, hold the outer ring with a pair of pliers, insert the twister, and twist.
Print spec
- Formats
- gcodestl
- Model files
- 4
- Total size
- 1.7 MB
- Largest file
- 1,010.2 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-
New -
New -

-


