Skip to main content
F3D
Nắp vặn cho búa tháo đầu đạn… 1

2 images

DIY

Nắp vặn cho búa tháo đầu đạn (Inertia Bullet Puller Screw Cap)

By Dinosauer_778137

Downloads
121
Likes
10
Views
632

Files 1 1.5 MB

  • Entladehammer_Schaubdeckel_1777630885.stlSTL · 1.5 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Drucktipps

  • Sie können die Kappe mit dem kleinen Loch auf das Druckbett setzen. 
  • Keine Supports erforderlich. 
  • Empfehle einen äußeren Rand. 
  • TIPP: Wenn Sie das Loch schließen möchten, damit Pulver nicht versehentlich ausläuft, können Sie einen inneren Rand hinzufügen. 
  • Verwenden Sie keinen 100%igen Infill, sondern erhöhen Sie die Wandstärke auf 20. Dies erhöht die Qualität des Slicens und optimiert den Druckkopfweg in kreisförmige Bewegungen. Das ist viel stabiler und ergibt eine bessere Schichthaftung. 
  • Kühlen Sie die Schichten nicht zu schnell ab. Verwenden Sie keinen Druckbettlüfter, der Druckkopflüfter reicht aus.

Printing hints

  • You can place it with the small hole on the build plate.
  • No supports needed.
  • Reccomending an outside brim.
  • if you want to close the hole so that there are no accidential spill outs of powder, you can add an inside brim.
  • Don't use 100% infill, instead increase wall thickness to 20. This increases the slicing quality and optimises the printer head movement in circular fashion. Way more stable and better layer adhesion.
  • Don't cool the layers too quick. Don't use additional auxiliary fans, print head fan is enough.

Thank you for downloading my model.

If you could help me out with a like, i'd greatly appreciate it. Hope you find the model helpful.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
1.5 MB
Largest file
1.5 MB

0 comments

See all