Skip to main content
F3D
Cán thay thế cho công cụ RC và dụng cụ khác 1

14 images

DIY

Cán thay thế cho công cụ RC và dụng cụ khác

By Cico_999391

Downloads
54
Likes
7
Views
261

Files 6 11.6 MB

  • rucka_1_1766688717.stlSTL · 3.3 MB
  • rucka_3_1766688719.stepSTEP · 179.1 KB
  • rucka_2_1766688719.stepSTEP · 173.6 KB
  • rucka_1_1766688720.stepSTEP · 174.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#35592
Category
DIY
Published

Description

Náhradní rukojeť.

Na ručce, co používán na RC modely, jsem si strhl závit na pojišťovacím šroubu a nástroj se protáčel v ručce.

Nakreslil jsem novou rukojeť ,která lépe padne do ruky .

Na fotkách lze vidět i původní poškozené  rukojeti.

Rukojeť lze upravit ne jen na RC nářadí.

Upravil jsem ji třeba i pro malé sklíčidlo nebo pro nástrčné klíče a přiložil soubory (i step).

Pro zajištění proti protočení u bitu je použit červík M3x5mm.

(Replacement handle. On the handle, which is used on RC models, I tore off the thread on the locking screw and the tool was spinning in the handle. I drew a new handle that fits better in the hand. The original damaged handles can also be seen in the photos. The handle can be modified not only for RC tools. I modified it, for example, for a small chuck or for socket wrenches and attached the files (including the step).)

(A worm screw M3x5mm is used to prevent rotation of the bit.)

Tisk (print):

Materiál: PLA, PET-G, ABS, nebo lepší.(or better).

Výška vrstvy (layer height): 0.3mm

Perimetry (perimeters): 5

Výplň (infill): 40% Gyroid

Podpěry (Supports): ne (no)

Jestli vaše tiskárna málo chladí nastavte obrys v prvních 5 vrstvách 10mm od objektu ať má materiál dole na rukojeti čas zchladnout.

(If your printer does not cool enough, set the skirt in the first 5 layers 10 mm from the object so that the material below the handle has time to cool down.)

Read more Show less

Print spec

Formats
stepstl
Model files
6
Total size
11.6 MB
Largest file
3.9 MB

0 comments

See all