Skip to main content
F3D
Nhà cho chim (Bird house) – dễ lắp, không cần support 1

8 images

Đồ Gia Dụng

Nhà cho chim (Bird house) – dễ lắp, không cần support

By Didier_196275

Downloads
1,401
Likes
282
Views
6,652

Files 11 53.4 MB

  • Cabanne_Bv2_1777541951.3mf3MF · 1.6 MB
  • Cabanne_Bv2_-_Haut_1777541953.3mf3MF · 1.6 MB
  • Cabanne_Av2_-_Haut_1777541954.3mf3MF · 2.6 MB
  • Cabanne_Av2_-_Toit_1777541955.3mf3MF · 2.6 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#354666
Category
Đồ Gia Dụng
Published

Description

Wanted a bird house easy to install which could have an organic feel. Made the base removable if ever we need to clean it. I had some fun playing with the spline to build various form and could not establish which one is the most interesting so I have uploaded a couple.

That is build to not require any support. The hole is 30 mm to attract mostly small birds. The hole in the top is build to slide a cord into it.

Technically the bases is the same for all design but just for simplicity I have uploaded one per.

2022-05-10 modified the design for the main one to incorporate feedbacks.

  • Added a slot in the bottom to add fixing the base to the top
  • Reduce friction by increasing the gap for the filet between the top and the base to 0.2 mm instead of 0.1 mm
  • Add bigger flat in the top hole to make it more robust and better seat washer if someone it that for fixing the rope
  • Added the small top over the hold to prevent rain from getting in the bird house.

2022-05-14

  • Reduce the size of the base to simplify assembling pieces.
  • Also added a version B with a different form and single piece since adding the cord is not that hard so the removal base is not that useful
    • In that new design I added vent holes after reading more on bird house.
    • Also make it less wide to save on print time and material. 

2023-07-29

  • Created a new base with a bigger space to make it less fit one removing 1.1 mm and one 1.8 mm.
  • Exported in 3MF instead of OBJ
  • Exported both the version with and without the small wimsy roof

2024-02-23

  • Exporting again the base since there might be an issue with the version. Each are to accomodate issue with printer tolerance. I used the -0.8 mm for my version.
  • The -0.4 should be the best fit but require the printer and materiel to not shrink to fit.
  • The -1.1 are -1.8 are removing 1.8 mm which are not recommended and you might end up gluing the piece. But if you print are shrinking a lot that could help

Printer Brand:

Prusa

Printer: 

Mk3

Rafts:

No

Supports: 

No

Resolution:

200

Infill: 

38

Filament:
PolyMaker PETG

Category: Outdoor & Garden

Read more Show less

Print spec

Formats
3mfobjstl
Model files
11
Total size
53.4 MB
Largest file
13 MB

0 comments

See all