
Saturn 3 Ultra (Ống gió + Quạt + Nam châm hít)
- Downloads
- 103
- Likes
- 14
- Views
- 1,019
- Remixes
- 0
- Comments
- 0
Files 4 461 KB
- duct_2x_tube_1777334587.stlSTL · 215.6 KB
- duct_2x_v2_fan_side_1777334588.stlSTL · 106.4 KB
- duct_2x_v2_enclosure_side_side_1777334589.stlSTL · 106.4 KB
- duct_cover_1777334590.stlSTL · 32.5 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #346709
- Category
- Máy In 3D
- Published
Description
There should be 3 files. One that goes on the enclosure, one that goes on the fan, and one that goes on the fan and tube. The sides that faces the fan should be the wider beveled side. Tube side does not use magnetics, I put tape over them to prevent air escaping. Magnets should be push all the way to the side where other magnets will connect. Rubber band is for creating a tighter seal. I printed in PETG. No supports or brim needed.
UPDATE: I added a cover for both enclosure and fan side. It uses 5x4mm magnets since I ran out of bar magnets.
- 25X4X3mm Magnets Bar (8x)
- M3 x 12 + washers (12x)
- 60mm diameter air duct tubes
- Air duct clamps or zip ties
- A rubber band
- 90mm fan and power source
- 5x4mm magnets (4x optional for cover)
Print spec
- Formats
- stl
- Model files
- 4
- Total size
- 461 KB
- Largest file
- 215.6 KB
0 comments
You may also like 12 models
See all-

-
New -
New -

-

-

-

-

-

-

-

-


