Skip to main content
F3D
Bracket khe mở rộng PiSCSI cho Macintosh SE và SE/30 1

11 images

DIY

Bracket khe mở rộng PiSCSI cho Macintosh SE và SE/30

By PotatoFi

Downloads
165
Likes
12
Views
1,916

Files 6 3.1 MB

  • RaSCSI_Expansion_4_1777321707.stlSTL · 323.9 KB
  • RaSCSI_Expansion_3_1777321708.stlSTL · 355.6 KB
  • PiSCSI_Internal_Mount_2_and_3_1777321709.stepSTEP · 621.5 KB
  • PiSCSI_Expansion_Bracket_4_1777321711.stepSTEP · 529.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

The PiSCSI is an exciting project by the retro Mac community, which turns a Raspberry Pi into a virtual SCSI device. It can host virtual hard drives and CD-ROM drives, which can all be attached and detached through a web interface hosted on the Raspberry Pi itself. Soon, the PiSCSI might also function as a virtual Ethernet adapter, simultaneously solving the storage and connectivity problems of 68k Macs!

This bracket mounts your Raspberry Pi and PiSCSI in the expansion slot on your Macintosh SE or SE/30, so your RaSCSI can be permanently installed inside your Mac. You can use the PiSCSI for hosting virtual hard disks, hosting virtual CD-ROM drives, and for network connectivity through the emulated Ethernet adapter. Power can be provided by the power supply on the Macintosh. The PiSCSI is controlled via web browser on another device (another computer, phone, or tablet).

Parts

To install your Raspberry Pi and PiSCSI in your Macintosh SE or SE/30, you'll need:

  • x2 M3 screws (at least 6mm long)
  • x2 M3 nuts
  • x4 M2.5 11mm standoffs
  • x4 M2.5 screws
  • x1 Molex power cable (recommended cable)
  • x1 SCSI ribbon cable (unfortunately, the original cable is too short)

Installation

If you build your own PiSCSI, you can omit the microUSB port, as well as the DB-25 port to streamline the assembly process (or you can leave them installed).

To power the PiSCSI, I recommend cutting the end off a Molex power cable (leaving the male plug/female pins side), removing the +12v (yellow) wire and adjacent ground (black) wire, leaving just the +5v (red) and ground (black). Then, solder the red wire to the the 5v through-hole on the PiSCSI, and the black wire to the GND through-hole.

You can plug the Molex connector into the hard drive power connector on your Mac.

Release Notes

v1

  • Initial release

v2 (2024-04-01)

  • No changes to models
  • Removed 1.0 models (they no longer serve a purpose)
  • Updated license from non-commercial/no derivatives to a more permissive license
  • Uploaded .F3D and .STEP files

Read more Show less

Print spec

Formats
f3dstepstl
Model files
6
Total size
3.1 MB
Largest file
710.2 KB

0 comments

See all