
Giá đỡ màn hình mỏng xtouch cho máy in 3D
Remix of Giá đỡ màn hình P1Touch By leejsmith
- Downloads
- 311
- Likes
- 49
- Views
- 2,251
- Remixes
- 1
- Comments
- 8
Files 3 1.8 MB
- xtouch_case_mount_1766318475.stlSTL · 79 KB
- xtouch_case_top_1766318476.stlSTL · 526.6 KB
- xtouch_case_bottom_1766318477.stlSTL · 1.2 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #34359
- Category
- Máy In 3D
- Published
Description
Update: added cutout for sd card access.
I have redesigned the xtouch screen mount by Xps3riments/leejsmith to use a snap case that is slimmer and doesn't require any screws, The snapping is an accident but it holds well enough for it's purpose.
It mounts using 2 magnets that press fit in the back side of the case. I use 10x3mm magnets easily available on Amazon. 2 more magnets are press fitted onto the screen mount. I wanted something that can be portable so went for a less permanent fixture method.
Mount the PCB by pushing the board down until the screw holes snap into place. The standoffs for the pcb have a little overhang, so that's why there's a bit of stringing, but it works ok and it all prints ok without supports.
Without the mount it can also serve as a case for CYD ( cheap yellow display) ESP32 projects.
Print spec
- Formats
- stl
- Model files
- 3
- Total size
- 1.8 MB
- Largest file
- 1.2 MB
8 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-

-

-

-



