Adapter thay thế xTOOL S1 Exhaust 3" (77mm) – Replacement Exhaust Adapter

About the design

I recently bought an xTOOL S1 diode laser engraver/cutter. Once unpacked it was found that the exhaust port adapter that is supplied with the S1 is too large to connect to the xTOOL Fume extractor that I also purchased.  

My version of the exhaust port adapter allows the S1 to connect to a 3" (77mm) flexible extractor tubing. It uses the same footprint as the original adapter, and utilizes the same Four M3 screws.  Created in Alibre Atom3D.

Parts

• 1 - printed exhaust port adapter
• 4 - M3 screws (from existing unit)
• 1 - 90mm pipe/tube clamp
  •  or Zip ties.

Printing info

• 4 walls
• 0.24 layer height
• PLA/ABS/PETG material
• 30% infill
• Supports = YES 
  • Threshhold Angle = 25 deg
  • On build plate Only