Skip to main content
F3D
Ngàm gắn SKÅDIS cho Wera Hex-Plus 1

2 images

DIY

Ngàm gắn SKÅDIS cho Wera Hex-Plus

By nmattia

Downloads
681
Likes
106
Views
2,211
Remixes
2

Files 3 178 KB

  • Wera_Hex-Plus_Skadis_mount_1777006727.3mf3MF · 31.1 KB
  • Wera_Hex-Plus_Skadis_mount_1777006728.stlSTL · 48.2 KB
  • Wera_Hex-Plus_Skadis_mount_1777006729.stepSTEP · 98.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 2

See all 2 remixes

Description

This is a skadis mount for Wera's Hex-Plus kit. Print-in-place, with supports. The mount just clips into the skadis board, and the Hex-Plus kit can be slid in.

If you like this model, check out SKÅPA for generating custom parts for SKÅDIS

Print Instructions

Any layer height should do, the model in the pictures was printed with a 0.6mm nozzle, 0.2mm layer height. Do enable support material. If possible use at least 3 perimeters. The support material is used to support the upper set of clips in the back.

Read more Show less

Print spec

Formats
3mfstepstl
Model files
3
Total size
178 KB
Largest file
98.8 KB

0 comments

See all