
Giá đỡ ADXL345 cho máy in Elegoo Neptune 3 Max
- Downloads
- 146
- Likes
- 10
- Views
- 1,252
- Remixes
- 1
- Comments
- 0
Files 2 69.5 KB
- ADXLMount_1766479490.stlSTL · 26.4 KB
- ADXLMount_1766479491.stpSTP · 43 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #33096
- Category
- Máy In 3D
- Published
Description
This model offers a convenient mount point for resonance-testing the Y-axis on the massive Neptune 3 Max. It uses the punched holes already present on the textured PEI sheet that comes standard with the Max.
It may work for other printers, too, but the holes are specifically aligned to the Max's bed sheet (A STEP file is provided for those who want to modify it for your own printer).
In addition to the model, you'll need the following screws, along with the ADXL345 itself and an MCU (I use a Raspberry Pi 3B) running Klipper or other input-shaping firmware.
- 2 M3x8 (or M3x12) screws w/ nuts to mount platform on bed
- 2 M3x12 screws w/ nuts to mount ADXL board to this platform.
Enjoy your printer!
Note: You should onlykeep this attached to the bed while you're performing resonance calibration, as the printhead may otherwise hit the ADXL or cable during bed-leveling or printing (although I suppose you could mount the chip under the PEI sheet if you wanted to make it permanent for some reason).
Print spec
- Formats
- stlstp
- Model files
- 2
- Total size
- 69.5 KB
- Largest file
- 43 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-

-

-



