Giá đỡ Macro/Copy Stand

Macro/copy stand is suitable for any kind of macro photography, including the digitization of negatives/positives.

Materials needed:

• 8 screws 40x6 mm (hex head)
• 1 screw 15x6 mm (hex head)
• 9 hexnuts for the screws above
• Optional: Thin shims
• A pole with a 25 mm diameter, in my case, a pole from the Dremel workstation but this one from Biltema should work as well.
• Cutting board, in my case, bought at Clas Ohlson, with dimensions 34.5 x 24.5 x 1.5 cm
• Tripod screw
• Arca-Swiss plate
• 4 screws 4x20 mm and 4 hexnuts
• 4 x furniture feet
• 22 mm coach/wood screw

Print settings:

All parts can be printed in draft mode and without support.

PETG was used.

Instructions:

Attach the tripod screw to the red part and mount it to the grey part using the 4x20mm screws and nuts.

Attach the feet to cutting board by using the coach/wood screws, put on furniture feet.

Drill holes for the copy stand in the cutting board. Attach the pole holder.

The lower screw (black ring) is a safety stop for your camera. The lower screw on the grey part should add some friction to the pole and the upper screw is the one use to adjust the height of the camera.

Do you like it? Please consider to buy me a cup cup of coffee.