Ốp rail Magpul Type 2 (M-lok) in 3D

Magpul Rail cover type 2

made in Fusion 360.

This works just like the real thing, insert the base into an m-lok slot on your handguard, click in the "locktab" and its done. No extra's needed, only 3D printed parts. And best of all, when printed right, it's stuck real good, pretty much zero movement.

- Support is already build in, so support should be off in your slicer.

- Use a Raft on both prints, otherwise something will probably come loose while printing cause of the small surface area of these things.

- Both files are in the position they should be printed in.

(The locktab may look weird, but it's at a 45 degree angle, so most printers should be able to print it without support turned on, make sure to use a raft tho)

The fit can be a bit loose depending on the quality filament you use. If this is the case, just put "Horizontal expansion" at 0.05 when printing the rail cover base. That way the fit should be better. (Keep in mind that it's only stuck tight after inserting the "lock tab")

When inserting the locktab, make sure to line up the little holes you can see at the bottom (see last image). Because of some difficulties the model isn't perfectly symmetrical so that's why it needs to be lined up.

-- I would love to see some Makes--

Print Settings

Printer:

Artillery Sidewinder X1

Rafts: 

Yes

Supports:

No

Resolution: 

0.2

Infill:

33% Triangles, 3 Walls/Perimeters

Filament:

Real filament / 123D Filament PLA

Matt black / Bronze Custom Section ==============

When inserting the locktab, line up these holes (last image). the other way around wont fit perfectly, because it isnt perfectly symmetrical.

Category: Sport & Outdoors