
Phần nối dài giá đỡ cuộn filament Ender 3 (Ender 3 spool holder extension)
- Downloads
- 109
- Likes
- 11
- Views
- 667
- Remixes
- 0
- Comments
- 0
Files 3 11.6 MB
- FilHolderExtension_1776773502.stlSTL · 4.8 MB
- FilHolderExtension_Shorter-PM-spool_1776773507.stlSTL · 4.8 MB
- FilHolderExtension_1776773508.FCStdFCSTD · 2 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #321908
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
A spool holder extension that simply plugs into the original one. I designed this to be able to use some wider spools (like from PM) without risking them falling off.
You can use it with or without the nut in the middle, depending on what your spool requires. The extension just clicks in place when inserted all the way through.
However, it is designed for the original version of Ender 3 (mine is from 2018) and users of recent Enders have reported it does not fit the newer spool holder design. Please check the model dimensions will fit before printing! Or at least compare your holder design to my photos.
It is an extension, not a replacement, for a simple reason: better load capability. The original tube is very rigid, but short. Using an extension that runs through it, I use it to support the extended part, dramatically reducing forces that could cause layer separation on the printed piece if it had a similar overall length. Therefore it should hold multi-kg spools easily.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
10% Cubic
Filament: Filament PM (Plasty Mladeč) PETG Transparent Blue
Notes:
Unless your bed adhesion is horrible, no raft or brim is needed. PETG is preferred, but PLA should work too. Simply print in the supplied orientation.
Use at least 1.2mm walls and 1mm top/bottom thickness for rigidity.
Post-Printing
No postprocessing needed. Simply slide it into the original spool holder tube from the back until it clicks in place. Remove the original nut first if necessary for your spools.
How I Designed This
Designed in FreeCAD, the file is included for potential remixing ;)
Category: 3D Printer Parts
Print spec
- Formats
- fcstdstl
- Model files
- 3
- Total size
- 11.6 MB
- Largest file
- 4.8 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -
New -

-

-

-

-


