Case siêu nhỏ cho Heltec LoRa v3 dùng Meshtastic

I bought a few Heltec boards and wanted to print some cases.
Found a few already on Printables but i found a few problems: there are big, hard to print or not fitting the bigger antennas that were in my kit.

The goal for this case was:

• Really small
• A loop to hang it
• Support bigger antenna

So how small is it?

Compared to the H1 case it is a few mm smaller in the height and length

Parts needed:
 

• A Heltec board (i bought this set)
• 2x heat set inserts M3 X D4.6 X L5.0
• 2x M3 8mm socket heat bolt

This is probably the first version of this housing because it is not perfect yet. But before making a new version, i want to use it a while to know what changes are needed but some i can think of now:

• The loop can be a bit bigger
• Support for seeing to light also with less transparent filament
• The routing of the antenna cable is a bit hard
• Make a version that can fit a battery and/or gps
   

Selling of this case it not allowed without my approval. 
Will be added to my EU Etsy store soon