
Bộ lọc remix cho chân Pogo loại khác
- Downloads
- 113
- Likes
- 32
- Views
- 1,234
- Remixes
- 0
- Comments
- 17
Files 8 6.5 MB
- mounting-bracket-center-5-mm-deph-for-pogo.stlSTL · 1.3 MB
- right-side-mag-mount-5mm-deph-for-pogo.stlSTL · 586.7 KB
- filter-housing-center-5-mm-deph-pogo.stlSTL · 2.1 MB
- left-side-mag-mount-5mm-deph-pogo.stlSTL · 561.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #313
- Category
- Máy In 3D
- Published
Description
Wasn't intended to publish, but since some people asked me on VoronDesign for the files, i have decided to share it. I got the steps from github and the missing one directly from nateb16 (nate5815 on discord) that i greatly thanks for his amazing job.
Since the original version was designed for this type of Pogo, and that i didn't want the USB cable at the back, i have decided to remix it for this kind of Pogo (ø 10 mm / 3A / 2 pins / 5 mm deph) and the original wasn't adapted for.
Remixed then :
- the center filter housing
- the center mounting bracket
- the left side mag mount
- the right side mag mount
Else was ok (all Lids, left and side housing) and can be found there : https://github.com/nateb16/VoronUsers/tree/master/printer_mods/nateb16/THE_FILTER
Pogo i used (will need 3 if you are planning to install side and center and only one if center only) : https://fr.aliexpress.com/item/1005004182554268.html?spm=a2g0o.order_list.order_list_main.75.19be5e5bDBANyI&gatewayAdapt=glo2fra
Also you can find on my printables the Hub and the wiring guide i used on my pics.
I also ran quite some measurements before and after installing The Filter (to compare to Nevermore V5) to see the improvement. Had 2 NTC 100 K thermistor, one at the back of the gantry, and one at the top front of the frame near the doors. I can assume that Nevermore is heating/blowing to the top of the enclosure first, when The Filter is heating/blowing to the middle of the enclosure around the gantry/head, then the top of the enclosure. That's obvious you would say. But actually, it clearly heating almost 1.5x to 2x faster than Nevermore (obvious again with 2 more fans).
On the graph i compared (with the 2 thermistor each time, during 1 hour heatsoak) :
- With Nevermore V5 and no bath towel (cheap tip to improve insulation) on Voron
- With Nevermore V5 with bath towel on Voron
- The Filter 4 fans with bath towel
You can see the graph on the pics i joined as well.
Print spec
- Formats
- stlstp
- Model files
- 8
- Total size
- 6.5 MB
- Largest file
- 2.1 MB
17 comments
You may also like 12 models
See all-

-

-

-

-

-
New -
New -

-

-

-

-


