
Chân vịt thuyền 20cm, 13cm & 10cm, trục 10mm
- Downloads
- 2,266
- Likes
- 117
- Views
- 7,122
- Remixes
- 1
- Comments
- 0
Files 6 26.1 MB
- 20cm_10mm_1776465909.3mf3MF · 1.5 MB
- 20cm_15mm_1776465910.3mf3MF · 1,002.2 KB
- 13cm_10mm_flat_1776465911.3mf3MF · 562.3 KB
- Parametrised_MK7_10cm_10mm_flatter_1776465911.3MF3MF · 3.5 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #307005
- Category
- DIY
- Published
Description
Boat Propeller I designed to electrically drive my canoe. It can be driven with a battery drill.
Edit: /* To clear things up a bit.
20cm_10mm.3mf is a propeller with 20cm diameter and a hole for a shaft with 10mm diameter. 30° tip angle; 314mm/rev pitch
20cm_15mm.3mf is a propeller with 20cm as well and a hole with 15mm diameter.
NEW Model: 13cm_10mm_flat.3mf has 13cm diameter and 10mm shaft, it is a bit flatter and has a less “aggressive” angle. Better for low torque and higher RPM motors. 30° tip angle; 204mm/rev pitch
NEW Model 2: Parametrised_MK7_10cm_10mm_flatter.3MF
10cm diameter 10mm shaft; 30° tip angle; 157mm/rev pitch;
13cm_10mm_flat.3mf and the 10cm version need support.
Scale any of them to fit your needs ;-)
*/
There is a version with a 15mm hole that can be scaled down to 66,67%(20cm_15mm.3mf) in the slicer to get the 13cm diameter propeller with a 10mm hole. Or you scale down the 20cm(20cm_10mm.3mf) one to 60% to use it with a 6mm shaft.
Use M5 screws to fix on the shaft.
The print time indicated is for the 66% version.
The smaller version is easier to handle and more adequate in size for a small canoe, however it needs higher rpm (+-2000rpm) to work well.
Print instructions
Can be printed without support. I printed it in ABS.
13cm_10mm_flat.3mf needs support.
Print spec
- Formats
- 3mfgcodestep
- Model files
- 6
- Total size
- 26.1 MB
- Largest file
- 15.9 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-
New -

-

-

-
New -



