
Đế giữ bộ sạc TORRAS cooling Qi2
- Downloads
- 0
- Likes
- 0
- Views
- 66
- Remixes
- 0
- Comments
- 0
Files 3 1.7 MB
- nosac_za_ladni_punjac_1775637057.fcstdFCSTD · 128.7 KB
- nosac_za_ladni_punjac-Body_1775637059.stepSTEP · 214.1 KB
- nosac_za_ladni_punjac-Body_1775637059.stlSTL · 1.3 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #291655
- Category
- Dụng Cụ Tiện Ích
- Published
Description
TORRAS charger have the ring on the back so you can put your hand on the desk and angle it with that ring but on the cluttered desk I am always searching where the charger is so decided to make a holder similar to ones for magsafe.
TORRAS cool the phone while charging so it expels hot air. I printed in PETG, prints without any supports 0.2mm layer height
Open the ring and just push it through the slot. Rotate the charger so that you get usb-c where you like it. No special channel on the stand for cable as I found no need for it.
Source file in FreeCAD available
Print spec
- Formats
- fcstdstepstl
- Model files
- 3
- Total size
- 1.7 MB
- Largest file
- 1.3 MB
0 comments
You may also like 12 models
See all-
New -
New -

-
New -
New -

-

-

-

-

-

-


