
Kẹp mini giữ cuộn dây cho bàn làm việc
- Downloads
- 291
- Likes
- 47
- Views
- 1,462
- Remixes
- 1
- Comments
- 5
Files 3 1.3 MB
- screw_half_1_1766522838.stlSTL · 571.4 KB
- screw_half_2_1766522839.stlSTL · 574.8 KB
- mini_vice_1766522840.stlSTL · 202.9 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #28620
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
I needed a mini-clamp to hold down my spool holder to my desk and mistertech's design was just about what I had in mind, minus the headphone part. I also shortened the clamp down to 20mm because my desk is very thin. I also wanted the screw to withstand more tension, so I decided to split the original model and print both halves horizontally and acetone weld them after.
If you want the whole bolt or a larger version, check out the original design.
Print instructions
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 30%
Post-Printing
Acetone weld
With a small paintbrush, cover the flat surface of each screw half with acetone. Quickly, before the acetone evaporates, align the halves and hold together firmly for a few seconds.
Print spec
- Formats
- stl
- Model files
- 3
- Total size
- 1.3 MB
- Largest file
- 574.8 KB
5 comments
You may also like 12 models
See all-
New -

-

-
New -

-

-

-

-
New -

-
New -
New


