Skip to main content
F3D
Giá đỡ màn hình TFT50 cho máy in Elegoo Neptune 3 Pro/Plus/… 1

4 images

Máy In 3D

Giá đỡ màn hình TFT50 cho máy in Elegoo Neptune 3 Pro/Plus/Max

Remix of Giá đỡ màn hình cảm ứng TFT50 cho Sovol SV06 By ddan1924_546630

By Aaron Roach Roach

Downloads
191
Likes
58
Views
3,070
Comments
8

Files 2 1.2 MB

  • mounting_bracket_1766365859.3mf3MF · 970.2 KB
  • bracket_backplate_1766365860.3mf3MF · 268.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a display mount for the BigTreeTech TFT50 touch display for Elegoo Neptune 3 Pro/Plus/Max series printers.

This mount replaces the included display and mount, and re-uses the screws from the original display mount.

There is room on the back to enclose a Raspberry Pi 4, and the back cover includes cutouts for GPIO pins, ribbon cables for the display and camera, USB and ethernet ports, and the power input. The 1.0 version of the cover does not include cutouts for the 3.5mm audio jack or mini-HDMI cables.

This has been tested with the V2.0 TFT50 display that has the brightness dial instead of the buttons. You will want to adjust the brightness before assembling everything else.

Klipperscreen works (almost) out of the box. If you install a mainsail image to your raspberry pi, via the official Raspberry Pi imager, you just need to follow the instructions for installing KlipperScreen and configuring it within Mainsail, the instructions for how to do this can be found here.

If you have not yet installed Klipper on your Neptune 3 Pro/Plus/Max you can follow this guide to get started. You will probably want to build and flash your own firmware (which is fairly simple if you use the built-in make menuconfig command)

Read more Show less

Print spec

Formats
3mf
Model files
2
Total size
1.2 MB
Largest file
970.2 KB

8 comments

See all