Giá đỡ bàn in nam châm cho Elegoo Centauri Carbon

Magnetic Build Plate Holder for housing a single Build Plate.  It uses 3mm x 6mm Magnets that can be pushed into the housing on the back of the model.  It is a tight enough fit but can be glued for a more permanent solution.

I slide them out of the way and place my plate on the holder and then slide the holder into position.  There are (4) holes per piece so (16) total magnets needed if you plan on printing all four corners.  

Plate Holder = This can be printed twice if so desired.

Plate Holder 2 = This can be printed twice if so desired.