Giá đỡ công cụ cho máy in 3D Ender 3 V2

I like the design of @model_flyer's toolbox (https://www.thingiverse.com/thing:4796912), but it was a bit too close to the X gantry, and my hex keys didn't sit right in the original model (those supplied with Ender 3 v2 were too long). Also my calipers didn't fit right :)

My model is tested with Ender 3 v2 only, without the right side display, because mine has been moved to the left. Also, my printer is raised because of the improved cooling, otherwise the whole thing would be too low to fit calipers and hex keys without touching the base below printer.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

0.28

Infill:

35

Filament: Fiberlogy PLA Vertigo

Category: 3D Printer Accessories