Skip to main content
F3D
Cây chổi lau vòi phun Bambu X1/P1P (chổi+PTFE) 1

3 images

Máy In 3D

Cây chổi lau vòi phun Bambu X1/P1P (chổi+PTFE)

Remix of Bambu x1 D3vil wipe - Bộ lau vòi phun cải tiến By D3vilDesign

By Arough_296617

Downloads
919
Likes
236
Views
14,775
Remixes
2
Comments
49

Files 8 699 KB

  • default_BambuNozzleWiper_PTFE_wiper_19mm_v2_1766513238.3mf3MF · 81.9 KB
  • BambuNozzleWiper_PTFE_wiper_18.5mm_v2.3mf_1766513239.3mf3MF · 28.2 KB
  • BambuNozzleWiper_PTFE_wiper_17.5mm_v2_1766513240.3mf3MF · 29 KB
  • default_BambuNozzleWiper_brush_block_v2_1766513240.3mf3MF · 225.7 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 2

See all 2 remixes

Description

========================================================
Update v2:

I shortened the wiper a bit, as it was scraping pretty hard against the nozzle.
This is because of less springiness in comparison with the stock wiper.
I also rounded the edge on the block part, where the wiper pushes against, for hopefully more springiness.
You can mix and match both versions. Everything should fit.

The length of the wiper is from the bottom of it to the top of the PTFE tube when mounted.
Just for reference and if you need a custom one.
========================================================

I liked the idea of having a brush nozzle wiper to get rid of the gunk on the nozzle.
But I had problems with only the brush, as sometimes a lot of filament got tangled in the brush.

This is my attempt at combining the brush wipers with the stock PTFE wiper.
I changed the length of the printable stock wiper to fit the height I needed.
I then added a hole to the bottom of the brush wiper to fix the new wiper with the screws provided by the stock wiper.

I saw a similar design by @PaintballDNA_197233, but as he wasn't ready to release it into the wild I made my own.

Printing:

  • Orientation should be already correct in the files. You can also see it in the pictures.
  • Enable normal support for the PTFE wiper. The block should print fine without additional support.
  • I printed both parts with 100% infill which seems to work fine.

Assembly:

I made a short video of the assembly:


I forgot to mention cutting the brush bristles to size.
The original model said 20mm from the bottom of the print to the tip of the bristles.
I cut them to ~19.3mm to not brush against the silicone sock on the nozzle.

For the original instructions look at the model this is a remix of: 
https://www.printables.com/model/407433-bambu-x1-nozzle-brush
Just add the printed stock wiper part before fixing the whole thing to the printer.



I also added my attempt at combining the two models into one.
This is just cobbled together, doesn't print all that nice, and is not tested as of yet.
Don't expect it to work reliably.

If you have any ideas on how to improve the design, need a version with slightly other dimensions, or have general questions, just ask.

Read more Show less

Print spec

Formats
3mf
Model files
8
Total size
699 KB
Largest file
225.7 KB

49 comments

See all